-
86 -
1 -
18 -
10
177 plików
6,65 GB


Method 1 (software):
Instruction below obtained from official Flir Support:
----------------
There is a pinhole reset button on the bottom of the FLIR ONE near the charging port. Please complete the following steps :
1. With the FLIR ONE attached to the iPhone, power on FLIR ONE i.e., move the shutter arm to the middle position
2. Press in and hold the reset button for 30 seconds using a paper clip or something similar
3. Keep the FLIR ONE powered on for 24 hours to allow the battery to completely drain
4. Charge the FLIR ONE for 1-2 hours.
5. Connect the FLIR ONE to your iPhone 5 to test function.
6. Try with another cable/charger in another power outlet.
If none of this works, there may be a problem with the battery of the device because it has reached its lifetime.
-----------------------------------------
Method 2 (hardware):
1. Start with 30 s button reset, then turn off device.
2. Open and teardown your Flir One using this video as instruction
3. Disconnect every wire inside, especially battery
4. Clean using alcohol every contact
5. Assembly device as shown on screen
5. Check if it works pressing micro switch on PCB (shown on picture below)
6. Assembly device
- sortuj według:
-
0 -
2 -
0 -
0
2 plików
2,39 MB